An accessory item for the Reverse Chucking Jig.  This is a small 1 3/4" diameter head for use with small bowls and applications in hollow turning with small openings.
This small head attaches with a set screw to the Reverse Chucking Jig system developed by Alan.  It is held with a set screw to the shaft, and also uses textured rubber matting to drive the piece.    The head is made from solid aluminum and can be reduced further in size by light turning with a scraper.  However,  do not reduce the size any more than 1/4", to a 1 1/2 diameter--sometimes necessary to fit the opening of a hollow-turned vessel.   The second photo shows a comparison along side the original Reverse Chucking Jig--with the entire jig sold separately from this small head, and necessary to use this head.